Step 12 -Height Indicator Attachment - BALLHOG Ascent Series Manual

STEP 12 -HEIGHT INDICATOR ATTACHMENT

•
Measuring from the top of the rim to the top of the playing surface, adjust the height of the rim to lowest corresponding height
listed on the height sticker.
•
Make a reference mark on the inner portion of the jack at the bottom of the outer sleeve.
•
Adjust the backboard to its lowest point and apply the (#2) height decal to the inner portion of the jack lining the reference mark
up with the corresponding height on the decal as shown in Image 13.
Note: You may apply the (#2) height decal to the side or the rear of the jack. When applying to the rear of the jack, a portion of the
height decal may need to be trimmed off. While this is a rare occurrence, it is possible depending on the height of your anchor system
in relationship to the slope of the driveway where the rim height measurement was taken.
Image 13
1
TOP OF JACK
2
7' 6"
8' 6"
9'
9' 6"
10'
BOTTOM OF JACK
PAGE 17
888.496.5137
b h g
all og oals.com