Table of Contents
Advertisement
www.ti.com
2.3.2
HSDC Pro GUI Configuration
1. Open High Speed Data Converter Pro by going to Start Menu → All Programs → Texas Instruments →
High Speed Data Converter Pro. The GUI main page looks as shown in
2. When prompted to select the capture board, select the TSW14J56 whose serial number corresponds
to the serial number on the TSW14J56EVM and click OK. This popup can be accessed through the
Instrument Options menu.
3. If no firmware is currently loaded, there is a message indicating this. Click on OK.
SLAU687 – May 2016
Submit Documentation Feedback
Low Level View Tab
Figure 3. ADS54Jxx GUI Low Level View Tab
Figure 4. HSDC Pro GUI Main Panel
Copyright © 2016, Texas Instruments Incorporated
USB Status
Load Config
Figure
4.
Quick Start Guide
7
ADS54J20EVM
Advertisement
Table of Contents
