Pentair Pentek Solar Drive Hardware - Pentair Pentek Solar Drive PSD30 Installation And Operation Manual

PENTAIR PENTEK
The Pentair Pentek Solar Drive controller consists of several components, as shown in Figure
5. The unit has five wire glands: one large gland for a motor cable (middle), two glands for solar
PV arrays (right side), and two glands for data cables (left side), a float switch sensor or other
optional sensor. There is direct access to the power and signal terminals on the DIN rail once the
enclosure door is removed.
The Pentair Pentek Solar Drive controller should be mounted on a wall or other vertical surface
using the back bracket (see Figure 5 below). On the back side of the unit there are two set screws
used to hang the unit on the back bracket. More detailed mounting instructions are shown below.
Back Bracket (Wall Mount)
Electrode Lug
Integrated DC Disconnect
1
Fix the back bracket to the
support surface by inserting
four screws (not included)
through the 4 holes in the
back bracket
P1062 (06/06/19)
SOLAR DRIVE HARDWARE
*
Ground
Signal Wire
Glands
Back View
2
Make sure all 4 set
screws are used to hang
the PicoCell onto the
back bracket
Figure 5: Pentair Pentek Solar Drive Hardware
Mounting
Holes
Heatsink
Motor ON/OFF
Switch Power Wire Glands
(Motor and Both Solar Inputs)
Front View
Shoulder Bolt
3
Once the PicoCell is
in place on the back
bracket, install the
shoulder bolt to secure
the unit to the bracket
7