Table of Contents
Advertisement
www.ti.com
1.12.2 ALP does not detect the EVM
If the following window opens after starting the ALP software, double check the hardware setup.
It may also be that the USB driver is not installed. Check the device manager. There should be a "HID-
compliant device" under the "Human Interface Devices" as shown below.
The software should start with only "DS90Ux929" in the "Devices" pull down menu. If there are more
devices then the software is most likely in demo mode. When the ALP is operating in demo mode there is
a "(Demo Mode)" indication in the lower left of the application status bar as shown below.
SNLU172 – January 2015
Submit Documentation Feedback
Figure 1-18. ALP No Devices Error
Figure 1-19. Windows 7, ALP USB Driver
Copyright © 2015, Texas Instruments Incorporated
Troubleshooting ALP Software
DS90Ux929EVM User's Guide
23
Advertisement
Table of Contents
