Star Micronics TSP100 Hardware Manual page 14

Paper roll holder
Tear Bar Model
Note: When using a paper roll with an 57.5
mm width, install the paper roll holder
in the groove in the printer.
If a paper roll with a 57.5 mm width
has been used, a paper roll with a
79.5 mm width cannot be used.
(Changing from the smaller roll to a
larger roll will cause part of the
print head to rub against the platen
and deteriorate.)
3) Push down both sides of the printer cover
to close.
Note: Make sure that the printer cover is
securely closed.
4) Tear Bar Model:
Tear off the paper as shown.
Auto Cutter Model:
If the printer cover is closed after turning
on the power, the cutter operates automati-
cally and the front end of the paper is cut.
– 11 –