Grounding The Vdp 80.1; Technical Data; Display - Bosch Rexroth IndraControl VDP 80.1 Series Manual

Machine operator panel operator display
Table of Contents

Advertisement

DOK-SUPPL*-VDP*80.1***-PR03-EN-P
Rexroth IndraControl VDP 80.1 Machine Operator Panel Operator Display
4.4

Grounding the VDP 80.1

4.5

Technical Data

4.5.1

Display

The HMI operator panel housing has to be equipped with a fan. However,
the fan should be positioned directly at the operator to prevent dust from
settling on it.
Installing a filter device for ventilation purposes is recommended. Addi‐
tionally, a heat exchanger has to be installed in case of a considerably
high ambient temperature.
The EMB of the housing for the HMI operator panel has to be taken into
consideration.
The components in the HMI operator panel housing have to positioned to fa‐
cilitate easy access during maintenance work.
The VDP 80.1 has to be grounded to ensure correct operation. The required
minimum cable cross section is 2 mm
GND in the grounding diagram stands for the service ground of the system,
supplying the reference voltage 0 V. FG stands for shield ground, reducing the
cross interferences.
The shielding of the connecting cable has to be soldered properly
with the jacket of the cable connector for all parts of the system.
All shieldings of the electronic unit should be connected to GND.
Display area
Diagonal display size
Screen actuation
Display colors
Resolution
Cycle life of backlight
Fig.4-11:
Technical data display
Ambient temperature: 25 °C
Cycle life of backlight:
The cycle life of the backlight is limited to a certain amount of op‐
erating hours. Once the time has lapsed, the brightness of the
backlight only amounts to 50% of the original value.
LCD display:
The readability of the LCD display continuously decreases due to
a low backlight. In this case, the backlight has to be exchanged.
Please contact the Bosch Rexroth service for further information.
Bosch Rexroth AG
Dimensions, Installation and Wiring
.
2
VDP 80.1, CNC milling
211.2 (H) x 158.4 mm (V)
26 cm (10.4 inch)
a-Si TFT Active matrix
262.144 colors
640 (H) x 480 pixel (V)
50.000 hrs
27/61
VDP 80.1, CNC turning
170.88 (H) x 128.16 mm (V)
21 cm (8.4 inch)
a-Si TFT Active matrix
262.144 colors
640 (H) x 480 pixel (V)
50.000 hrs

Advertisement

Table of Contents
loading

Table of Contents