Star Micronics TSP1000 Series User Manual page 23

Position 5
Position 4
Position 3
Position 2
Position 1
(3) Pull on the edge of the paper to
(4) If the printer cover is closed after
(5) If necessary, attach the paper stop-
Position 1
Position 6
Position 2
Position 3
Position 4
Position 5
Position 6
– 19 –
remove any slack and then push
down both sides of the printer cover
to close.
Note: Make sure that the printer
cover is securely closed.
turning on the power, the cutter op-
erates automatically and the front
end of the paper is cut.
Note: If the cutter does not operate
after the printer cover is
closed, open the cover and
close it again securely.
per to the paper cover as shown
below. The output tray can hold up
to 30 sheets (thickness: 80–105 µm,
length: 50–150 mm).
Note: When attaching the paper
stopper to the paper cover,
position the stopper accord-
ing to the length of the cut
paper. (Refer to the follow-
ing table.)
Paper length (mm)
50 – 100
100 – 120
120 – 140
140 – 160
160 – 180
180 – 200