Installation Sequence; Siting The Combi Cylinder - Viessmann VITOCELL 360-M Installation And Service Instructions Manual

Siting the combi cylinder

1.
4.
1. Remove all packs from the cylinder
body, and keep safe.
2. Insert the adjustable feet into the hex-
agon nuts as far as they will go and
level the cylinder.
Note
Never wind out the feet more than 35
mm.
2.
3.
3. Install the thermal insulation mat
under the cylinder body.
4. If no immersion heater is installed,
seal the front female connection with
the plug supplied (R 1½).

Installation sequence

9