Stanton RM-406 Owner's Manual page 16

Application Example
This is a typical setup you'll find in many nightclubs: 2 turntables, 2 CD play-
ers, plus a microphone for the DJ. Here's how you would set up your equip-
ment with the RM.406:
1. Be sure all equipment is powered "OFF" and all of theRM.406's Channel
faders and Level knobs are at minimum volume.
2. Connect the turntables to the Phono inputs of Channels 1 and 4. Be sure
the rear-panel toggle switch for Channel 4 is set to "PH2" or you won't hear
anything. To avoid hum, don't forget to connect the ground wires to the
grounding terminals.
3. Connect the CD players to the inputs of Channels 2 and 3. (if your CD play-
er supports fader start connect applicable cables)
4. If your CD players support Fader Start, connect the mini-cables and set the
Fader Start switches to "ON".
5. Depending on the type of cable you have, connect your microphone to the
Mic1, 2, or 3 (1/4" / XLR) input.
6. Connect the Master Output jacks to the club's power amp, EQ or
crossover. Then connect your monitor amp to the Booth output. If you have a
separate amp for a particular area of the club, connect this amp to the Zone
outputs.
7. If you wish to use an effects processer (sold separately) connect the appro-
priate cables from the send output connecters of the mixer to the IN on your
processer. Then connect appropriate cabless from the OUT of your process-
er to the RETURN on the rear connections of the mixer.
8. Set the Input Selectors on the front panel to the appropriate inputs for each
channel.
9. Power everything up and carefully adjust the input levels using the Input
Gain knobs and Mic Level knob.
10 Slowly raise the Channel faders, Master fader, Booth level, Zone level and
Mic level as appropriate and start mixing!