Stamina 55-1539 Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
RIGHT
STEP 10:
Slide the
ASSEMBLY.
Make sure the
PROTECTIVE COVERS(26, 27).
NOTE: Do not secure the
SECURING STRAPS
STEP 11:
Attach the
KNOB(11)
. Slide the
and secure in position with the
STEP 12:
Attach the
(M8 x 25mm)(46), WASHERS(M8)(51),
PROTECTIVE COVERS(26, 27)
BOLTS. Pull the
FOLDING LINKAGES(3).
than the
LINKAGES
with the
PROTECTIVE COVERS(26, 27)
NOTE: When the
(3)
should not be visible.
STEP 13:
Verify that the handlebars function correctly before using the
Move the Nylon Bed on the
must move forward as the
ASSEMBLY STEPS 2, 11, and 12.
forward check
(10) Handrail
Shaft
LEFT RIGHT PROTECTIVE COVERS(26, 27)
and
SHAFTS
PROTECTIVE COVERS(26, 27)
on the covers until
LINKAGE(7)
onto the
LEFT HANDRAIL ASSEMBLY(8)
LOCKING KNOB(11).
LINKAGES(7)
onto the
Secure the
SECURING STRAPS
MAIN FRAME(4)
MAIN FRAME(4)
Shaft
FRONT FRAME(1)
on the
STEP 12.
LEFT HANDRAIL ASSEMBLY(8)
onto the
Repeat on other side.
LEFT RIGHT PIVOT ARMS(5, 6)
and
NYLOCK NUTS(M8)(49).
and
down until the bottom of the covers are slightly lower
PROTECTIVE COVERS(26, 27)
on the covers.
are assembled correctly the
backward toward the inverted position. The
moves backward. If the
9
Nylon Bed
LEFT
onto each side of the
poke out through the hole on the
FOLDING LINKAGES(3)
to the
SHAFT
in the
DO NOT OVER TIGHTEN THE
FOLDING LINKAGES
Therapy Inversion System.
HANDRAILS(10)
(10) Handrail
BASE
with the
LOCKING
with the
FRONT FRAME(1)
BOLTS
with
FOLDING
to the
HANDRAILS(10)
do not move