Stamina 55-1539 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
Buckle
1.
2.
Buckle
STEP 7
HEIGHT ADJUSTMENT BEAM(12)
Install the
MAIN FRAME(4)
on the
SECURING KNOB(23)
safety, thread the
WARNING:
Do not use the
Failure to use the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT
STEP 8
NYLON STRAP(31)
Attach the
the end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 9
NYLON STRAP(31)
Hook the end of the
BUCKLE STRAP(32)
end of the
NYLON STRAPS
NOTE: The
For a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps. Make
NYLON STRAPS
sure these
Therapy Inversion System.
A.
B.
C.
HEIGHT ADJUSTMENT BEAM(12)
and inserting the
into the back side of the
Therapy Inversion System
instructions on page 10.
BUCKLE
onto the
onto the loop on the back of the
onto the loop on the
are used to control the decline angle of the
are tight in the buckle and check the decline angle before using the
MAIN FRAME(4)
into
MAIN FRAME(4).
until you have verified your height setting.
BUCKLE STRAP(32)
on the end of the
FRONT FRAME(1).
8
SPRING PIN(22)
by pulling the
as shown. For added
MAIN FRAME(4).
Therapy Inversion System.
by inserting
Hook the