Stamina 55-1539 Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
STEP 4:
Attach the
ADJUSTMENT KNOB(24).
NOTE:
The four adjustment holes in the
four different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.
STEP 5:
Insert the
BEAM(12)
and secure with
HEEL HOLDER BRACKET(18)
Place a
HOLDER TUBE(17)
STEP 6:
Insert the
PAD TUBE(14)
into the
OUTER PAD TUBE(15)
WASHERS(M6)(50),
OUTER PAD TUBES(14, 15).
PAD TUBES(14, 15)
WARNING:
The
The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
inversion table.
FOOTREST(13)
HEEL HOLDER TUBE(17)
BOLT(M6 x 47mm)(44), WASHERS(M6)(50),
together. Repeat on other side.
OUTER PAD TUBE(15)
OUTER PAD TUBE(15).
LEVER(56),
, and
NYLOCK NUT(M6)(48).
and
HEIGHT ADJUSTMENT BEAM(12)
onto the
FOOTREST(13)
allow the
through the hole on the
HEEL HOLDER(19),
onto a
through the hole on the
Align the holes on the
then bolt them together with
Slide the
must be assembled with the ends pointed downward as shown.
7
FOOTREST(13)
HEIGHT ADJUSTMENT
NYLOCK NUT(M6)(48).
and
then slide them onto
LEVER(56).
INNER PAD TUBE(14),
BOLT(M6 x 42mm)(43),
FOAM PADS(16)
onto the
with the
to be attached in
HEEL
INNER
Insert the
INNER
and