AT&T RADIANT Core User Manual page 75

Turn Wi-Fi on and connect to a wireless network
Use the wireless and networks setting menu to enable your phone's Wi-Fi
radio and connect to an available Wi-Fi network.
1. From the home screen, swipe up to access Apps, and tap Settings
2. Tap Network & Internet > Wi-Fi.
3. Slide the Wi-Fi switch to the On
• Wi-Fi is enabled. You will see the names and security settings of in-
range Wi-Fi networks.
• To disable Wi-Fi, slide the Wi-Fi switch to the Off
4. Tap a Wi-Fi network to connect, enter the password (if it's not an open net-
work), and then tap Connect.
Your phone is connected to the Wi-Fi network. You will see
bar.
• The password, for a household wireless LAN router, is sometimes found
on a sticker on the router (WEP , WPA, KEY, etc.). Contact the router man-
ufacturer for information. For the password for a public wireless LAN,
check with the user's service provider.
• Entering a password is not required if an access point is not security
protected.
Note: The next time your phone connects to a previously accessed secured
wireless network, you will not be prompted to enter the password again,
unless you reset your phone to its factory default settings, or you instruct the
phone to forget the network.
position.
position.
in the status
.
75