Select Country; Auto Scanning; Manual Scanning; Reset To Factory Defaults - Samsung Plasma Display Panel Television Owner's Instructions Manual

Operating the DTV Menu

1.1 Select Country

To tune-in new channels, the TV has been provided with the option
"Select Country". Select the country where broadcasting services are
provided. After selecting the "Select Country" from the Installation
Menu, the following screen will be displayed:
• Select the country which you are in.
You can select the value of ITALY, SPAIN, SWEDEN, UK, USER, BELGIUM,
GERMANY, FINLAND, or FRANCE by using œ or √ button.
• After selecting option, press the ENTER/OK (
nation of broadcasting area to be served. If you don't want to save the
changes, press EXIT button without ENTER/OK (
➢
If national code is changed, all of saved programs will be deleted.
➢
USER: An user may set Channel Number and Frequency in Auto/Manual
scanning.

1.2 Auto Scanning

The sub menu "Auto Scanning" will enable download of the channels
automatically from the preprogrammed load.
To download channels automatically:
• You can select the specified frequency between Start Frequency and
End Frequency.
• Press the ENTER/OK (
Auto Scanning menu will be displayed.
All the channels in the list will be automatically downloaded.

1.3 Manual Scanning

To tune-in new channels and weak signals, the TV has been provided
with the option "Manual Scanning" where the channel data can be
entered by the user. After selecting the "Manual Scanning" from the
Installation Menu, the following screen will be displayed:
• Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can choose it.
Signal Status bar shows you if it is valid.
• Input the frequency of the channel you want to find.
• Select the bandwidth. You can select the value of 6 MHz, 7 MHz or 8 MHz.
• Select the Guard Interval Mode.
You can select the value of AUTO, 1/32, 1/16, 1/8, or 1/4.
• Select the FFT (Fast Fourier Transform) Mode.
One of the values-AUTO, 2 K, and 8 K- will be selected automatically.
You may change the set value as your preference.
• After selecting option, press the ENTER/OK (
scanning process.

1.4 Reset to Factory Defaults

This is to restore the factory set values in case the user has encountered
some problems after changing any values of channel data and others which
may be in error. At the request window, if you press the ENTER/OK (
button, the TV will be reset to factory default settings automatically.
➢
This causes your previous settings to be deleted!
) button to choose the
) button.
) button to start the
continued...
English - 27
) button pressed.
)
Installation > Select Country
Country œ œ
ITALY
œ œ /√ √ - select country, OK - confirm selection, EXIT/D.MENU -
exit this menu.
Installation > Auto Scanning
Country ITALY
Scan Mode Digital
œ œ
Start Frequency CH D/177500 kHz
End Frequency CH69/858000 kHz
œ œ /√ √ - select option, ... ... /† † - move, OK - start scan,
EXIT/D.MENU - exit.
Installation > Manual Scanning
Country ITALY
Scan Mode Digital
Channel Number œ œ
CH D
Frequency
177500 kHz
Bandwidth
7 MHz
Guard Interval
AUTO
FFT Mode
8 K
Signal Status
œ œ /√ √ - select option, ... ... /† † - move, OK - start scan,
EXIT/D.MENU - exit.
Installation > Reset to Factory Defaults
Installation
Select Country
Channel Organising
Auto Scanning
Manual Scanning
Parental Lock
Press OK to confirm selection or EXIT to
Reset to Factory Defaults
cancel.
System Setup
√ √
√ √
√ √