•
Do not twist or kink the cable, or wrap it round the appliance.
•
This appliance is not intended for commercial or salon use.
PARTS
1. On/Off switch
2. Zoom wheel
3. Length position indicator
4. Charge indicator
CHARGING YOUR APPLIANCE
Before using your trimmer for the first time, charge for 4 hours.
1.
Ensure the product is switched off.
2.
Connect the charging adaptor to the product and then to the mains.
3.
The charging indicator will illuminate.
•
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
•
On a full charge, your beard trimmer will run for up to 50 minutes of cordless usage.
CORDED
•
Connect the appliance to the mains and turn on.
•
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
FITTING THE ADJUSTABLE COMB
•
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to
keep it from turning. Ensure the length position indicator is at 1.5.
•
Slide the comb down the grooves until it clicks into place.
•
The comb can only be attached one way.
TO THIN AND TAPER THE BEARD/MOUSTACHE
1.
Fit the adjustable comb.
2.
Use the zoom wheel to set the comb to the desired length setting.
4
Charge Level
Charging
Fully Charged
5. Trimmer assembly
6. Adjustable comb
7. Adaptor (not shown)
8. Cleaning brush (not shown)
Indicator
LED will show
LED will turn off