Electrical, Location And Draining; Installation Requirements - Splendide 7100XC Instructions For Use Manual

Electrical
•
Machine Voltage/Amperage - 120V, 60 Hz,
1300 W, 10.5 Amp.
•
Connection - 3-prong plug with 6' cord is
provided with the machine.
•
Circuit/Protector - 3-wire single phase, 120V,
60 Hz, AC, on a separate 15 Amp circuit.
Location
•
This machine may be installed free
standing as well as in a recessed area,
closet, or alcove
•
Minimum Installation Spacing - 0" on
sides and 1" in front and back. NOTE:
Additional installation spacing needs to be
considered for easy installation, servicing,
and compliance with state and federal
codes.
•
Floor - Must support at least 280 lbs. and
be a solid, level surface. DO NOT install on
carpet.
•
RV/Marine Installations - When locating
the appliance in a towable trailer or
watercraft, position the machine over the
axles or mid-ship where movement is at a
minimum. Block the machine to prevent
extreme movement.
•
NO DRYER VENT - This appliance uses an
internal water condenser to dry laundry.
All humidity stays within the unit and is
drained as water. NO heated or
conditioned air is exhausted outside; NO
exhaust vent is needed.
If you have... You'll need...
no access to Hot/Cold Splendide Faucet Adapter
water hookups Kit, or equivalent.
concerns about the
Splendide SecureFit bracket
appliance shifting in
kit, or equivalent.
your RV or boat
water damage Splendide Drain-A-Way Pan,
concerns or equivalent.
Drainage
Standpipe Diameter/Capacity - Needs a 1 ¼"
minimum diameter standpipe with a minimum
carry-away capacity of 7 gallons per minute.
Top of Standpipe - Must be between 25" and 34"
high from the bottom of the machine.
Outlet End of Drain Hose (provided with the unit)
- Must be at least 20" above the bottom of the
washer-dryer. An air break must be available at the
standpipe to avoid siphoning. No more than 6" of
the drain hose should be inserted into the drain
pipe to prevent siphoning.

Installation requirements

7