Mounting The Loop Handle - Stihl KM 90 R Instruction Manual

Mounting the Loop Handle

A barrier bar is supplied with the
machine. Attach the barrier bar to the
loop handle.
2
1
Insert square nuts (1) in the barrier
N
bar (2) – the holes must line up
KM 90 R
4
5
6
1
Insert the clamp (3) in the loop
N
handle (4) and position them
together on the shaft (5)
Position clamp (6)
N
Position barrier bar (2) – note
N
position!
Line up the holes
N
Insert bolts (7) in the holes – and
N
screw them into the barrier bar as
far as possible
2
3
7
A
8
9
Fit the loop handle (4) at a distance
N
of (A) approx. 20 cm (8 in) forward
of the control handle (8)
Orient the loop handle
N
Tighten the bolts – lock the nuts if
N
necessary
The sleeve (9) is present depending on
the country and must be located
between the loop handle and control
handle.
Always leave the barrier bar attached.
English
4
9