Troubleshooting - HoMedics mybaby SoundSpa MYB-S500 Instruction Manual And Warranty Information

Using Attachment Straps:
IMPORTANT: Please check the unit frequently to ensure it is still secure.
NOTE: Do not attach to playpens or mesh walls.
The attachment straps are not intended for use as a toy. Please make sure the attachment straps are out of
reach from children.
1. To secure the Snail to a crib, first ensure the straps are positioned correctly on the back of the product
(Fig. 5). The square part of the strap should sit evenly against the body of the Snail. The straps slide
under the Position Bar.
2. With the straps properly positioned, place the Snail up against the top rail of the crib, with Snail facing
into the crib.
3. The straps will loop around the top bar, with the ends coming back against the Snail's body (Fig 6).
4. Press the peg on the square part of each strap through the hole in the strap end as shown (Fig 7).
Make sure the peg is fully inserted through the hole. You should feel a slight "pop" as the peg
securely positions into the strap hole.
5. Press lightly but firmly down on the product body to ensure it is securely attached to the crib.
6. Use attached strings to tie Snail securely to the crib (Fig 6).
Position Bar
Figure 5 Figure 6
IMPORTANT: Check the unit frequently to ensure it is still secure. Failure to attach to crib in the exact
manner shown may result in product falling into crib. Take care to follow directions exactly.
Figure 7
4
Using the Snail Base:
1. When not attached to a crib, the Sleepy Snail may be placed on the included base for added stability.
2. Note the arrow showing which direction the Snail face should point (Fig 8).
3. Push the strings through the base, into the side of the middle base section that has the string loop
guide (Fig 9).
4. Loop the strings loosely around the loop guide to secure them.
5. Set Snail and base onto a smooth flat surface out of reach of child. Press down lightly to ensure the
Snail is secured in base.
Figure 8 Figure 9
Care:
• Keep the unit clean by wiping it with a clean, slightly damp cloth.
• Do not immerse this product. Keep away from moisture and water.
• Remove batteries from battery compartment if product will not be used for an extended period of time.
• Keep the device out of direct sunlight for extended periods of time and away from any source of direct heat.
• Do not drop product onto hard surfaces.
Trouble Shooting:
If the unit stops working please check the following before calling Homedics Consumer Relations for support.
• Using a coin, open the battery compartment door to access the batteries
• Remove the batteries.
• Wait 1 minute, and then replace the batteries. Ensure the batteries are inserted in the correct
polarity positions.
• Press the POWER button to turn on. The product should now work correctly.
• If the device still does not function, open the battery compartment and replace all batteries with
new batteries.
If the problem persists, contact Homedics Consumer Relations at 1.800.466.3342 or
email Support at cservice@homedics.com.
5