HoMedics mybaby SoundSpa MYB-S500 Instruction Manual And Warranty Information page 2

WARNING: All packing material, such as tape, packaging locks, and sticker tags are not part of this
toy, and should be discarded for your child's safety.
NOTE: Please keep this instruction manual as it contains important information.
How To Install Batteries:
• This product takes 3 C batteries. Do not use rechargeable batteries.
• Open the battery panel door on the bottom of the toy (Fig. 1a) using a coin to unscrew the door screw.
• Insert batteries into compartment in the direction shown, with the negative (-) end pointed back into
the compartment (Fig 1b).
• Replace battery door and use coin to secure the battery door screw.
NOTE: When sounds or light become faint or stop, it is time for an adult to change the batteries.
Caution: All servicing of this product must be performed by authorized HoMedics Service Personnel only.
Figure 1a – Figure 1b –
Battery Door On
Battery Door Off
Buttons Overview
The controls for Sounds are located on the right side of the Snail (Fig. 2). The controls for the
Lights and Projection features are located on the left side of the snail (Fig. 3). The Projection Selection knob is
located at the top of the projection piece (Fig. 4).
Auto-timer
Melodies
Sounds
Volume -/+
Power
Figure 2 Figure 3
Projection
Lights
2
Listening to the Sounds/Melodies:
• To turn the sounds on, press the POWER button on the top right panel (Fig. 2).
• Sounds will gradually increase to last played volume.
• To change sounds or melodies, press either the Sounds or Melodies button until you hear the sound or
melody you want. The Sound Button will toggle between the 5 Sounds. The Melodies Button will toggle
between the 5 melodies.
• To turn off Sounds or Melodies, press the POWER button.
NOTE: When the unit is turned on, it will always default to the last sound used.
Using the Lights Display function:
• To turn the Lights Display on, press the LIGHTS button on the top left panel (Fig. 3).
• The lights will turn on and begin random display of colors.
• To increase the brightness, press the LIGHTS button a 2nd time.
• To turn the Lights Display off, press the LIGHTS button a 3rd time.
NOTE: Lights Display will automatically turn off after 5 minutes.
Using the Projection function:
• To turn the Projection on, press the PROJECTION button on the top left panel (Fig. 3).
• The image projection will turn on and projecting images onto the ceiling. 3 individual images will fade in and
out in a sequence (see Changing Scenes to switch between image scenes).
• To increase the brightness, press the PROJECTION button a 2nd time.
• To turn the Projection off, press the PROJECTION button a 3rd time.
NOTE: Projection will automatically turn off after 5 minutes.
Changing Scenes:
• To change from one image scene to another, turn the rotation disk on the top of the
projector (Fig 4).
• Turn the rotation disk until you feel a light "snap" to indicate the disk is locked in its
proper position.
• To switch back to previous scene, rotate the opposite direction until you feel the
same light "snap".
• There are two image scenes: "bugs" and "animals".
Figure 4
3