Table of Contents
Advertisement
Instructions (Cont.)
Program notes
The programs table on page 18, opposite, lists each program's default parameters and
the range of available options.
Water temperature
This front load washing machine has one water connection for your cold water tap.
Most wash programs have a Cold wash option, which takes the water straight from the
tap. A thermostat inside the machine measures the temperature of the incoming water. If
it is too cold for the water temperature selected, the washer's internal heating elements
heat the water to the set temperature.
To change a program's default water temperature, press the Temp. button repeatedly
and select from the options available: Cold, 30°C, 40°C, 60°C, 80°C (not all options are
available for all programs).
Spin Speed
To change a program's default spin speed, press the Spin Speed button and select from
400, 600, 800, 1000, 1200, 1400 RPM (not all options are available for all programs).
+Rinse
To add extra rinse (or more) to a program's default rinse cycles, press the +Rinse button.
Extra rinses are not available for all programs.
Delay start
This function lets you delay the finishing time of the wash by up to 24 hours. It is
available for all wash programs. To set it:
1.
Use the program dial to switch on the machine and select your desired washing
program.
2.
Press the Delay Start button and choose the desired finishing time in one-hourly
intervals, up to a maximum of 24 hours.
3.
Press the Start/Pause button to start the delay operation.
4.
To change the delay time, turn the program dial to the stand-by position and then
reset the wash program and delay time.
5.
To cancel the delay function, turn the program dial to the stand-by position.
To check the delay time, press the Delay Start button and the delay time will be
6.
displayed for five seconds.
NOTE: The actual delay time varies depending on the selected program.
(AU) 1300 886 649 (NZ) 0800 836 761 |
After Sales Support
info@tempo.org
19
Hide quick links:
Advertisement
Table of Contents
