Assembly And Disassembly Procedures - Acer S230HL Service Manual

25 ACER S230HL
Go to contents page
4.1 Assembly Procedures（pure A monitor）:
1. Tightening the bracket of D-Sub on the Main board with two HEX-head screws.
S1
(The HEX-head screw size = MAC. SCREW-MHSW #4-40*5.0L,Ni)
2. Sticking the gasket on the bottom of bracket of D-Sub.
(Gasket size = 5.0W*3.5H*10.0Lmm)
3. Connecting LVDS cable to J3 connector of Main board.
S2
1: Putting the Panel on the protective cushion and let the glass side of panel face us. Then cover it with
Front Bezel
2: Turning over the panel.Put the main board on it and plug LVDS cable to CN1 connector of source
board (T-con).
S3
Using Acetate cloth tape to stick LVDS cable on the Panel firmly. (ACETATE CLOTH TAPE size= 60*80mm)

4. Assembly and Disassembly Procedures

1
2