Roland VersaUV LEF2-200 Setup Manual page 42

Connecting to the Computer
2.
Set the subnet mask.
Press [ ].
A
The screen shown below appears.
NETWORK
SUBNET MASK
Press [ ] twice to display the screen shown below.
B
SUBNET MASK
000.000.000.000
Press [ ] or [ ] to select the address number.
C
Press [ ].
D
Repeat steps
E
Note: For the subnet mask, make the setting the same value as the one used by the computer.
Here, "255.255.255.000" is entered by way of example.
SUBNET MASK
255.255.255.000
When you have finished making the setting, press [ENTER].
F
Press [ ].
G
The screen shown below appears again.
NETWORK
SUBNET MASK
If you connect the computer and the machine on a one-to-one basis, this completes the settings
to make on the printer. Proceed to "Step 3: Make the Port Settings for the Software RIP" (P.42).
If you need to set the gateway address, proceed to the following procedure, "3. Set the gateway
address." (P.41).
2.Installation
40
C D
and to set the subnet mask (255.255.255.0).