Table of Contents
Advertisement
The sound is working in my system, but when I play CD music from the CD-ROM, I
do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN1 connector in the M/B
is not connected. See manual for location of CDIN1.
The sound from my sound card is distorted when Windows start. What is wrong?
If you are using an ISA sound card, please make sure the IRQ needed for the sound card is set to ' L egacy
ISA' in the BIOS. In other word, if your ISA sound card takes IRQ5, then set IRQ5 to ' L egacy ISA' .
The sound and everything else works fine except that the recorder and microphone do
not work. What is wrong?
1.
Please go to sound properties and check if the recorder and microphone in the are enabled.
2.
Check if Microphone is ok.
The sound coming from my Center and Base speaker is interchange, what should I
do?
Set the JP1 and JP2 of the small audio card to pin2-3.
Hard disk/FDD/ CD-ROM issue
My Western digital HDD is not detected during boot-up
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not
1.
Check CD-ROM if it is working properly.
2.
The power supply might not have enough wattage to support all the peripherals. If your
system has other peripherals connected, like CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I got "floppy boot failure" and the LED on the
floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don' t
trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).
SY-P4X400 DRAGON Lite Quick Start Guide
27
Advertisement
Table of Contents
