Verifying The Kit Contents; Installing Software On The Host Computer - National Instruments R Series Getting Started Manual

3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.

Verifying the Kit Contents

Verify that the following items are included in the NI PXIe-7857R kit.
1. Hardware
2. NI-RIO Media
3. Getting Started Guide

Installing Software on the Host Computer

Before using the NI PXIe-7857R, you must install the following application software and
device drivers on the host computer.
1. LabVIEW 2016 or later
2. LabVIEW Real-Time Module 2016 or later
3. LabVIEW FPGA Module 2016 or later
4. NI R Series Multifunction RIO Device Drivers August 2016 or later
Visit ni.com/info and enter the Info Code
information.
Installing the NI PXIe-7857R
Caution
the device using the edges or the metal bracket.
1. Ensure the AC power source is connected to the chassis before installing the modules.
The AC power cord grounds the chassis and protects it from electrical damage while you
install the modules.
1
LabVIEW Real Time Module is only required when the R Series board is used in a chassis where
the PXIe Controller is running a real-time operating system.
Figure 1. NI PXIe-7857R Kit Contents
1
To prevent damage to the device caused by ESD or contamination, handle
2
1
softwareversion
NI PXIe-7857R Getting Started Guide
3
for minimum software support
| © National Instruments | 3