Wiring Diagrams - Southbend 1184093 Operator's Manual

T
ROUBLESHOOTING
BLOWER WHEEL REPLACEMENT
To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove side air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller disk (available from
Southbend as part number 1179100).

WIRING DIAGRAMS

A wiring diagram is located on the side of the control panel assembly (as shown on page 37). Wiring
diagrams also appear on the following pages of this manual. Which wiring diagram is appropriate depends
on the voltage and type of controls.
Index of Wiring Diagrams
Page Number Voltage and Type of Controls
39 208-240 Volt Models with Standard Controls
40 480 Volt Models with Standard Controls
41 415/240 Volt Models with Standard Controls
42 380/220 Volt Models with Standard Controls
43 208-240 Volt Models with Cycle/Cook & Hold Controls
44 480 Volt Models with Cycle/Cook & Hold Controls
45 415/240 Volt Models with Cycle/Cook & Hold Controls
46 380/220 Volt Models with Cycle/Cook & Hold Controls
47 208-240 Volt Models with Programmable or Rack Timer Controls
48 480 Volt Models with Programmable or Rack Timer Controls
49 415/240 Volt Models with Programmable or Rack Timer Controls
50 380/220 Volt Models with Programmable or Rack Timer Controls
P 38
AGE
H -S E
ALF IZE LECTRIC
O ' M 1184093
PERATOR S ANUAL
C O
ONVECTION VENS