Window Winders - Alfa Romeo STELVIO 949 Owner's Handbook Manual

WINDOW WINDERS

ELECTRIC WINDOWS
20)
They work with the ignition device in the
ON position and for about 3 minutes
after the ignition device has been turned
to the STOP position. When one of the
front doors is opened this operation is
disabled.
Driver side front door controls
The buttons are located on the door
panel trim. All windows can be controlled
from the driver side door panel fig. 34.
34
1: front left window opening/closing.
"Automatic continuous" operation during
window opening/closing and anti-pinch
system activated.
32
2: front right window opening/closing.
"Automatic continuous" operation during
window opening/closing and anti-pinch
system activated.
3: rear right window opening/closing.
"Automatic continuous" operation during
window opening/closing and anti-pinch
system activated.
4: enabling/disabling of rear door
electric window controls;
5: rear left window opening/closing.
"Automatic continuous" operation during
window opening/closing and anti-pinch
system activated.
Window opening
Push the buttons to open the desired
window.
When any of the opening buttons on front
or rear doors is pressed once briefly, the
window moves in stages; while pressing
the button for a second time, the
"continuous automatic" operation is
activated.
If the button is pressed again, the window
will stop in the desired position.
Window closing
04166V0001EM
Lift the buttons to close the desired
window.
The window closing stage occurs
following the same logic described for
the opening stage both of the front door
windows and the rear door windows.
Alfawiki.nl
Window anti-pinch safety device
This safety system can recognise the
presence of any obstacle during the
window closing movement. If this occurs,
the system stops the window's
movement and reverts it, depending on
its position.
The anti-pinch safety function is
activated both during the manual and the
automatic operation of the window.
Electric window system initialisation
If power supply is interrupted, the
electric window automatic operation
must be reinitialised.
The initialisation procedure described
below must be carried out with the doors
closed and for each door:
fully close the window to be initialised,
with manual operation;
after the window has reached the
upper end of travel, hold the up button
down for at least 3 seconds.
WARNING
20) Incorrect use of the electric windows
may be dangerous. Before and during
operation, always check that nobody is
exposed to the risk of being injured either
directly by the moving window or through
objects getting caught or hit by it.