Lane Departure Warning (Ldw) System - Alfa Romeo STELVIO 949 Owner's Handbook Manual

Table of Contents

Advertisement

IMPORTANT
43) The sensors must be clean of mud, dirt,
snow or ice in order for the system to
operate correctly. Be careful not to scratch
or damage the sensors while cleaning them.
Avoid using dry, rough or hard cloths. The
sensors should be washed using clean water
with the addition of car shampoo if
necessary. When using special washing
equipment such as high pressure jets or
steam cleaning, clean the sensors very
quickly keeping the jet more than 10 cm
away.
44) Have interventions on the bumper in the
area of the sensors carried out only by an
Alfa Romeo Dealership. Interventions on the
bumper that are not carried out properly
may compromise the operation of the
parking sensors.
45) Only have the bumpers repainted or any
retouches to the paintwork in the area of the
sensors carried out by an Alfa Romeo
Dealership. Incorrect paint application could
affect the operation of the parking sensors.
124
LANE DEPARTURE WARNING
(LDW) SYSTEM
DESCRIPTION
46) 47) 48) 49) 50) 51)
The Lane Departure Warning system
makes use of a camera located on the
windscreen to detect the lane limits and
calculate the position of the vehicle
within such limits, in order to make sure
that it remains inside the lane.
When one or both lane limits are
detected and the vehicle passes over one
without the driver's say-so (direction
indicator not turned on), the system
emits an acoustic signal.
If the vehicle continues to go beyond the
line of the lane without any intervention
from the driver, the surpassed line will
light up on the display (left or right) to
urge the driver to bring the vehicle back
into the limits of the lane.
SYSTEM ON/OFF
The system is activated/deactivated by
pressing the button, fig. 128
Each time the engine is started, the
system maintains the operating mode
that was selected when it was previously
switched off.
Alfawiki.nl
128
Activation conditions
Once switched on, the system becomes
active only if the following conditions are
met:
the car speed is above 37 mph
(60 km/h);
the lane limit lines are visible at least
on one side;
there are suitable visibility conditions;
the road is straight or with wide radius
bends;
a suitable distance is kept from the
vehicle in front;
the direction indicator (for leaving the
lane) is not active.
07226S0001EM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stelvio

Table of Contents