Resetting Error Codes; Error Codes - Samson TROVIS 3730-1 Mounting And Operating Instructions

10.1 Resetting error codes

The E0 and E3 to E8 error codes can be reset as follows:

10.2 Error codes

The errors listed in Table 17 are assigned to error classes:
− Error class 1: No operation possible
− Error class 2: Manual operation only possible
− Error class 3: Manual operation and closed-loop control possible
In TROVIS-VIEW, an additional icon for status classification is shown together with the error
(see Table 16).
Î If other malfunctions other than those listed in this section occur, contact SAMSON's
After-sales Service department (see section 12.1).
Table 16: Icon showing status classification
Icon Meaning
Failure
Function check
Out of specification
Maintenance demanded
No message
EB 8484-1 EN
1. Turn to select the error code.
2. Press , ESC is displayed. The error code blinks.
until RST appears.
3. Turn
4. Press to reset the error.
The reset procedure can be canceled by pressing rotary pushbut-
ton while ESC is displayed.
Malfunctions
91