Precautions For Installation - Panasonic WV-S3511L Important Information Manual

Precautions for installation

Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Power supply
This product has no power switch.
When performing electrical work, make sure the
camera can be turned on and off. When an
Ethernet cable is connected, the power is turned
on.
When cleaning the product, remove the Ethernet
cable from this product or turn off the system
power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
S3131 S3111
This camera is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this camera to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion.
Keep this camera away from water and
moisture.
S3531 S3511
Install the product in areas that do not
receive direct sunlight.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations near coasts directly subjected to
sea breezes, or locations subject to corro-
sive gases such as from hot springs, vol-
canic regions, etc.
• Locations where the temperature is not
within the specified range (☞ page 25)
S3531
S3511
• Locations subject to vibrations that exceed
the railway specifications (EN50155)
S3111
S3131
• Locations subject to vibrations, such as on
vehicles, marine vessels, or above product
lines (This product is not designed for on-
vehicle use.)
S3531 S3511
• Locations subject to sudden changes in
temperature such as near outdoor units of
air conditioners (In case of installing the
product in such locations,the dome cover
may become foggy or condensation may
be caused on the cover.)
S3111
S3131
• Locations where it may get wet from rain
or water splash (including under the eaves,
etc.)
13
S3532 S3512
S3532 S3512
S3532 S3512