Panasonic WV-S3511L Important Information Manual page 20

■ Indicators and buttons
AINITIAL SET button (Initializing button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
Disconnect the Ethernet cable from the camera.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to re-
lease the button after approximately 15 seconds. In about 2 minutes later, the camera will start
up and the settings including the network settings will be initialized. Retry if the camera does not
start up normally.
IMPORTANT:
⿟ When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
⿟ Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
BLINK indicator
⿟ When the camera is able to communicate with
the connected device
CACT indicator
⿟ When data is being sent via the network camera
AINITIAL SET button (Initializing button)
BLINK indicator
CACT indicator
D SD ERROR indicator
*This illustration represents WV-S3131L.
Lights orange
Blinks green (accessing)
20