Contents 1. Safety Instructions 2. Outline 3. Installation of driver 3.1 Automatic Installation 3.2 Manual Installation 4. ACT Controller Installation 4.1 Installation 4.2 Check of the Communication Port 4.3 Communication Setting 4.4 Functions of Each Mode No.JXC※-OMX0002...
Controller Setting Kit 1. Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of “Caution,” “Warning” or “Danger.” They are all important notes for safety and must be followed in addition to International Standards (ISO/IEC) , and other safety regulations.
Page 4
Controller Setting Kit Safety Instructions Caution The product is provided for use in manufacturing industries. The product herein described is basically provided for peaceful use in manufacturing industries. If considering using the product in other industries, consult SMC beforehand and exchange specifications or a contract if necessary.
When connecting the communication cable to the JXC□1 series, use a conversion cable. Conversion cable No.: P5062-5 *2) Prepare a USB cable (A-miniB) LEC-W2-U to connect the communication cable and PC separately. Caution The communication setting cable (LEC-W2A-C) is a dedicated cable for the applicable controllers.
3. Installation of driver 3.1 Automatic Installation Connect the communication cable LEC-W2A-C to the USB port of the PC in which Windows®10 has been installed via the USB cable (A-miniB), and start the PC device manager. When the USB driver is already installed on the PC, “USB Serial Port (COM□) “is displayed under “Port (COM and LPT)”.
3.2 Manual Installation Perform installation twice in the manual installation of the driver. Follow the procedure as outlined below: (1) Please download the USB driver from the SMC website. Create a folder on the PC and unzip the USB driver in the folder. When the driver is unzipped, the files below are displayed.
Page 8
(3) When the following screen is displayed, select the “Browse my computer for driver software”. (4) Then the following screen is displayed, so select the folder in which the USB driver is unzipped as the reference page and click “Next” No.JXC※-OMX0002...
Page 9
(5) When the driver is installed, “USB Serial Converter” is displayed under the Device Manager “Universal Serial Bus controllers” Installation needs to be performed once again, so right click the “USB Serial Port” under the Other devices“, then select “Update Driver Software”. (6) Installation must be performed in accordance with (3) and (4).
Page 10
(7) Then, the driver is installed and “USB Serial Port (COM□)” is displayed under “Ports (COM & LPT).” Manual Driver installation has been completed. No.JXC※-OMX0002...
4. ACT Controller Installation 4.1 Installation Install the controller setting software (ACT Controller), which has been downloaded from the SMC website. Create a folder on the PC and unzip the ACT Controller in the folder. Once the folder is unzipped, the ¥EN (Ver1200) folder is created, so execute the Setup.exe in the folder. When the installation is complete, “ACT Controller Menu”...
Confirm the following before starting communication. - The controller for communication and PC are connected using the USB cable (A-miniB) LEC-W2-U and communication cable LEC-W2A-C. (When connecting the communication cable to the JXC□1 series, use a conversion cable.) - Check that power is supplied to the connected controller.
The controller is not recognized if "Offline" is displayed in the red frame on the screen after starting the "Normal mode" as shown in the figure below. Check the communication port setting, wiring, and power supply to the controller and any other matter that may affect communication with the controller.