Search For Sensor; Clock And Calendar; Radio-Controlled Clock - Oregon Scientific BAR826HG User Manual

SEARCH FOR SENSOR

To search for a Thermo / Hygro sensor, press MODE to
navigate to the Temperature / Humidity Area.
next to the Area. Then, press and hold MEM CH for 2
seconds.
NOTE If the sensor is still not found, check the
batteries.

CLOCK AND CALENDAR

This product tracks the time and date based on radio-
controlled signals from the RTGR328N remote sensor,
or manual settings that you enter.

RADIO-CONTROLLED CLOCK

The time and date are automatically updated by radio-
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby
(England) unless you disable this feature. The signals
are collected by the remote sensor (RTGR328N)
whenever it is within 1500 km (932 miles) of a signal.
P/N:086-003808-011 REV1
12/162
BAR826HG_UM_EN.P65
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking.
will show
The
factors:
•
•
How these signals work together:
ICON
11
11
icon shown in the Clock Area indicates 2
Connection between the main unit and the sensor
that collects RF signals ( )
RF signal reception ( )
MEANING
The unit has contact with the sensor
and has synchronized the time.
The unit has contact with the sensor
but the time has not been
synchronized.
The unit has lost contact with the
remote sensor but the time is
synchronized.
The unit has lost contact with the
remote sensor and the time is not
synchronized.
The unit cannot reach the remote
sensor.
2005.3.8, 11:21 AM