Table of Contents
Advertisement
Chapter 2
Hardware Configuration and Installation
This chapter contains the instructions to configure and install the VXI-SB2020 interface kit. The
instructions are given in the order that you should perform them. A summary of the steps is as
follows:
1. Unpack the SB-MXI and VXI-MXI.
2. Install the SB-MXI hardware.
3. Configure the VXI-MXI hardware.
4. Install the VXI-MXI hardware.
5. Connect the MXIbus cable.
Step 1. Unpack the SB-MXI and VXI-MXI
Follow these steps when unpacking your SB-MXI board and VXI-MXI module:
1. Before attempting to configure or install the SB-MXI and VXI-MXI, inspect the shipping
container and its contents for damage. If damage appears to have been caused in shipment,
file a claim with the carrier. Retain the packing material for possible inspection and/or for
reshipment.
2. Verify that the pieces contained in the package you received match the kit parts list. (See
Chapter 1 of this manual.) Do not remove the boards from their plastic bags at this point.
3. Your SB-MXI board and VXI-MXI module are shipped packaged in antistatic plastic bags to
prevent electrostatic damage. Some of the circuitry on the SB-MXI and VXI-MXI use
CMOS technology and can be damaged by electrostatic discharge. Before removing the
boards from their antistatic bags, touch the bags to a metal part of your computer chassis.
4. As you remove the SB-MXI and VXI-MXI from their bags, be sure to handle them only by
their edges. Avoid touching any of the IC components or connectors. Inspect them for loose
components or any other sign of damage. Notify National Instruments if either board appears
damaged in any way. Do not install equipment that appears to be damaged.
© National Instruments Corporation
2-1
VXI-SB2020 and NI-VXI for Solaris
Advertisement
Table of Contents
