Hardware Configuration And Installation; Step 1. Configure The Hardware; Figure 2-1. At-Gpib Parts Locator Diagram - National Instruments AT-GPIB Getting Started
Getting started with your device and the ni-488m software for sco unix system v/386
Hide thumbs
Also See for AT-GPIB:
- Getting started (55 pages) ,
- Getting started (59 pages) ,
- Getting started (42 pages)
Table of Contents
Advertisement
Chapter 2
Hardware Configuration and
Installation
This chapter contains step-by-step instructions for configuring and
installing the AT-GPIB board in a PC AT.
Step 1. Configure the Hardware
Figure 2-1 shows the location of the AT-GPIB configuration jumpers and
switches.
Figure 2-1. AT-GPIB Parts Locator Diagram
© National Instruments Corp.
2-1
AT-GPIB for SCO UNIX
Advertisement
Table of Contents
