Ryobi RBL26G Original Instructions Manual page 17

GETTING STARTED
3
1
3
4
1. Align raised tabs on upper blower tube with the slots on blower housing outlet. 2. Attach and tighten securely by turning
clockwise until it clicks into place. 3. Attach desired nozzle to upper blower tube. 4. Tighten securely by turning clockwise
until it clicks into place.
10 11
6x
Pull the starter grip sharply until the engine starts. Do not When engine starts, wait and let it warm up for 10 seconds.
pull the starter grip more than 6 times.
GETTING STARTED
4
2
2
1
3
1. Loosen the fuel cap slowly by turning it counterclockwise.
2. Remove the fuel cap. 3. Pour the fuel mixture carefully
into the tank. Replace and tighten the fuel cap.
12
Set the choke lever to "RUN" position.
GETTING STARTED
5 6
10 10
Press the primer bulb 10 times or until fuel appears. Pull the cruise control lever back, towards the user.
13 14
Hold the blower with the upper handle in your right hand. To stop the engine, toggle the switch to the "STOP"
Hold the blower as shown so the air stream can work close position.
to the ground.
7
Set the choke lever to "FULL" choke position.
17