Ryobi RBL42BPN Operating Instructions Manual

Ryobi RBL42BPN Operating Instructions Manual

Backpack

Advertisement

RBL42BPN
BACKPACK BLOWER
OPERATOR'S MANUAL
Important!
It is essential that you read the instructions in this manual before
assembling, operating and maintaining this machine.

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi RBL42BPN

  • Page 1 RBL42BPN BACKPACK BLOWER OPERATOR’S MANUAL Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining this machine.
  • Page 2: General Safety Rules

    early in the morning or late at night when people might WARNING be disturbed. When using the product, the safety rules must be ■ Use rakes and brooms to loosen debris before followed. For your own safety and that of bystanders, blowing/vacuuming.
  • Page 3: Blower Safety Warnings

    ■ For refuelling and fuel mixing, chose an area away from WARNING sources of ignition (sparks, flames etc.), Flammable materials and which is well ventilated. Your back pack blower is fitted with a shoulder harness. Carefully adjust the harness to comfortably help to ■...
  • Page 4: Intended Use

    WARNING Do not operate without tubes in place. To avoid serious personal injury, do not attempt to use this product until you read thoroughly and understand Risk of loose clothing being drawn into air completely the operator’s manual. Save this operator’s intake.
  • Page 5: Specifications

    4. On/ off switch Regulatory Compliance Mark (RCM). 5. Adjustable harness and waist straps This product meets applicable regulatory requirements. NOTE: The straps are “quick release” type. 6. Choke Lever 7. Lower tube The following signal words and meanings are intended to 8.
  • Page 6: Operation

    ■ There are two possible height adjustment positions FILLING THE TANK that can be used to easily adjust harness. ■ Clean the surface around the fuel cap to prevent ■ Slip top buckle of harness from adjustment slot and contamination. position to desired height location.
  • Page 7: Operating The Blower

    6. Allow the engine to warm up for 30 seconds prior to WARNING use. To stop the engine: When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or ■ Set the On/ Off switch to "OFF" position. cause product damage.
  • Page 8: Spark Arrestor

    CLEANING THE AIR FILTER SCREEN STORAGE (1 MONTH OR LONGER) ■ Drain all fuel from the tank into a container approved See figure 6. for gasoline. Run engine until it stops. For proper performance and longer life, keep the air filter screen clean.
  • Page 9: Troubleshooting

    TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER. PROBLEM POSSIBLE CAUSE SOLUTION The spark plug may be damaged, remove it No spark. and check for dirt and cracks. Replace with a new spark plug. Push primer bulb until bulb is full of fuel.
  • Page 10 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 960478026-01...

Table of Contents