Inhibit; Viewing Input Channels And Input Details - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2

6.8 Inhibit

Note: Service or higher access level is required. (Analog input only)
Input channels can be inhibited by:
1) Selecting a channel and then touching the inhibit icon:
2) Remote inhibit input (locking switch)
To clear inhibits, select the required channel and then select Clear Inhibit.
Note: An auto-inhibit cannot be cleared manually. Auto-inhibits may occur during calibration or warm-up,
when a transmitter is signalling Inhibit, or when an Inhibit delay time is running.
Note: Inhibit timeouts can be set by configuring the channel, as shown below:

6.9 Viewing Input Channels and Input Details

From the Input screen, toggle the Home icon
Output.
1) From the Input screen, select Channel List or Channel Tile.
2) A list of all input channels is shown in order of channel ID. The channel ID, gas name, status
minimum/maximum peak concentration and current reading will be shown.
3) The list can be filtered by status – Alarm, Fault, Inhibit, Warning or All.
4) Select a channel and Channel detail screen will show up as shown below. Depending on access level, a
number of options will be shown.
Operating Instructions
53
between Channel Tile > Channel Summary > Channel
Touchpoint Plus Wireless
Technical Handbook