Komatsu 830E-AC Shop Manual page 1037

If the following procedures do not correct the problem, contact a factory authorized service center.
TROUBLE
Pump Does Not Operate
Pump Will Not Prime
Pump Will Not Build
Pressure
Injector Indicator Stem
Does Not Operate
Pressure Gauge Does Not
Register Pressure
P03030
SYSTEM TROUBLESHOOTING CHART
POSSIBLE CAUSES
Lube system not grounded.
Electrical power loss.
Timer malfunction.
Solenoid valve malfunctioning.
Relay malfunctioning
Motor or pump malfunction.
NOTE: On initial startup of the lube system, the timing capacitor will not contain a
charge, therefore the first timing cycle will be about double in length compared to
the normal interval. Subsequent timer cycles should be as specified.
Low lubricant supply.
Air trapped in lubricant supply line.
Lubricant supply line leaking.
Vent valve leaking.
Pump worn or scored.
NOTE: Normally, during operation, the injector indicator stem will move into the
body of the injector when pressure builds properly. When the system vents (pres-
sure release) the indicator stem will again move out into the adjusting yoke.
Malfunctioning injector - usually
indicated by the pump building
pressure and then venting.
All injectors inoperative - pump
build up not sufficient to cycle injec-
tors.
No system pressure to the pump
motor.
No 24 VDC signal at pump sole-
noid.
Pressure reducing valve set too
low.
24V Relay (RB7K8 or RB7K5) may
be defective.
Automatic Lubrication System
SUGGESTED CORRECTIVE ACTION
Correct grounding connections to pump
assembly and truck chassis.
Locate cause of power loss and repair. 24
VDC power required. Ensure key switch is
ON.
Replace timer assembly
Replace the solenoid valve assembly
Replace relay
Repair or replace motor and/or pump
assembly. (Refer to Service Manual for
rebuild instructions.)
Dirt in reservoir, pump inlet clogged, filter
clogged.
Prime system to remove trapped air.
Check lines and connections to repair
leakage.
Clean or replace vent valve.
Repair or replace pump assembly. (Refer
to Service Manual for rebuild instructions.)
Replace individual injector assembly.
Service and/or replace pump assembly.
(Refer to Service Manual for rebuild
instructions.)
Check hydraulic hose from steering sys-
tem.
Determine problem in 24 VDC electric
system.
Refer to "Pressure Control Valve Adjust-
ment".
Replace relay.
P3-13