Connections For A Digital Non-Linear Editing System - Sony 85P Operating Instructions Manual

Connections for a Digital Non-Linear Editing
System
This unit can be connected to an ES-7 EditStation to
configure a digital non-linear editing system.
If you use the QSDI interface, you can transfer video,
audio, time code, and other compressed data at quad
speed (four times the normal transfer rate) between
this unit and the ES-7.
The unit supports ClipLink functions, enabling index
pictures recorded on tape and ClipLink log data stored
in cassette memory to be transferred to the ES-7 in an
instant.
For a general description of ClipLink functions, refer to
"ClipLink™ Guide" supplied with the unit.
QSDI
REF. VIDEO IN INPUT
MONITOR
AUDIO
3
Audio input
Video monitor
Settings on the DSR-85/85P
Switch
REMOTE/LOCAL
REF. VIDEO IN 75 termination
For details of video/audio input and audio mode settings,
see "Settings for Recording" (page 19).
QSDI OUTPUT
VIDEO OUT 2
DSR-85/85P
(SUPER)
(recorder)
1
Composite video input
1 75
2 9-pin remote control cable (one cable
is supplied with the DSR-85/85P)
3 Cable with RCA phono plugs
(not supplied)
Setting
REMOTE
ON
The following figure shows a connection diagram for
non-linear editing system in which this unit serves as
the recorder.
For connections of the ES-7 and its peripheral devices such
as the ESBK-7011 Control Panel, the ESBK-7045 Disk Unit,
etc., refer to your ES-7 Operating Instructions.
Note
The example connections shown in this chapter
assume that DSR-85/85P, DSR-80/80P, and DSR-60/
60P units have DSBK-100/110/120/130 (or DSBK-
100P/110P/120P/130P) option boards installed.
1
B B OUT(1/2/3/4)
1
QSDI OUTPUT
1
QSDI INPUT
2
REMOTE RECORDER
coaxial cable (not supplied)
ES-7 EditStation
Chapter 5 Connections and Settings
57