For Accurate Learning - Sony RM-VZ950T Operating Instructions Manual

Operating Non-Preset
Components
— Learning Function (continued)
When you "teach" signals to the
2 +/– or buttons
If you have programmed any
signal on the 2 +/– or
for "TV" or "AMP" using the
Learning function, that signal will
not be transmitted. To use
"learned" signals, you need to
program the 2 +/– or
for each component using the
Learning function.
When you "teach" the signals
for an air-conditioner or
illumination
If you have unused components or
unused control buttons on your
Commander, you can "teach" the
signals for non-Audio Visual
components such as an air
conditioner.
Note
If you are "teaching" signals for an air
conditioner, you may need to perform
Learning anew every season.
When you "teach" the signals
for the amplifier
At Step 3 (page 16), the display
changes as shown below after
pressing the Jog dial.
A MP
N I PU
L E
Proceed "learning" from Step 4 to
7.
You can also "teach" the input
select (page 19).
18
GB
button
buttons
T
A R N

For accurate Learning

•Do not move the remote units
during the Learning procedure.
•Be sure to keep holding down
the "learning" button until your
Commander reacts as described.
•Use fresh batteries in both
remote units.
•Avoid Learning in places under
direct sunlight or a strong
fluorescent light.
•The remote control detector area
may differ depending on each
remote unit. If Learning does not
work, try changing the positions
of the two remote control units.
•When you "teach" signals of an
interactive signal exchange
system remote control unit
(supplied with some of Sony's
receivers and amplifiers) to the
Commander, the response signal
of the main unit may interfere
with the Learning of the
Commander. In such a case,
move to a place where the
signals will not reach the main
unit (e.g. other rooms, etc.).
IMPORTANT
Be sure to place the
Commander out of the reach of
small children or pets.
Components such as air
conditioners, heaters, electric
appliances, and electric
shutters or curtains receiving
an infrared signal can be
dangerous if misused.
Note
For details on the learnable remote
control signals, see
"Specifications" on page 35.