GBC FOTON 30 Installation & Operation Manual page 13

2. Remove Cartridge: Lift upward on the
cartridge handle to remove the installed
cartridge.
Caution: full cartridges tend to be
heavy
3. Insert Cartridge: Insert replacement
cartridge by aligning edges of cartridge over
grey channel guide in laminator and lowering.
Note: Film leader should be inserted
away from the feeder, facing
towards the exit of the machine.
4. Close Laminator Door: Close the laminator
door by gently lowering the door and fully
close the silver hatch on top. DO NOT push
down on the laminator door to close; use
the latch.
5. Ensure Cartridge is Fully Inserted: Film
6. Empty indicator will be illuminated when no
cartridge is installed or if the cartridge is
not fully seated on the bottom.
7. Automatically Thread: When the laminator
reaches proper temperature, the machine
will finish threading film and feed
approximately 22.9 cm of film to eliminate
potential wrinkles in the film.