Carbide Runner Replacement on FlexDie (200/200TC)
Carbide Runner Replacement on FlexDie (200/200TC)
Removal
1. Remove screed box.
2. Turn the die upside down, then use 5/8 wrench to
loosen nut 17D593 and 105327.
3. Remove die runner 17D502 and 17D504.
24
Installation
1. Apply grease to inside surface of carbide runner.
2. Replace die runner with new die runner.
3. Use two 5/8 wrenches to tighten the nuts.
NOTE: Make sure die runner can rotate freely after
the nuts are tight.
4. Install screed box.
ti26046a
ti26047a
a. Tighten the nut 105327 to make the die runner
just touch the pivot table.
b. Hold the wrench which is on 105327, use
another 5/8 wrench to tighten nut 17D593.
3A1320L