Table of Contents
Advertisement
REAR CENTER RAKE WHEEL KIT (OPTIONAL)
The center rake wheel kit is used to move the hay in the central part of the windrow. The hydraulic cylinder is
operated in parallel with the raising of the rake arms, therefore no further operations are necessary. The center
rake wheel normally moves very fast when working properly.
The compensating spring must be adjusted with the two holes (9) Asm-RK-0369 in raking arm, so as to obtain
the right pressure on the ground according to the desired working conditions. The shorter spring length
decrease the pressure on the ground.
If the working conditions do not require the use of the Center rake wheel, close the valve (5) Asm-RK-0372,
after having positioned the rake wheel arm in the raised position.
To lock the center rake wheel kit:
1. Activate the tractor hydraulic system and raise the fold-up arms up to the stops.
2. Turn off the tractor motor and remove the key.
3. Wait until all moving parts have stopped.
4. Close the valve (5) in Asm-TK-0372.
To assemble the center rake wheel kit: Asm-RK-0368
1. Remove the four bolts that connect the drawbar (A) at the four holes in plate (1).
2. Fasten the plate (1) using the long bolts (2) and the bolt (10) and nuts M16.
3. Insert the nylon bushing (3) into arm (4).
4. Attach the arm (4) to the plate (1) using the pin (6), washers (5) and spring pins (7). Mount grease nipple
(12)
XLRRX 06/18
© 2018 Alamo Group Inc.
ASSEMBLY
Item 2: 4 Bolt TE M16x150 (5/8"x5-57/64") DIN 931 8.8
Item 3: 2 Nylon Bushing
Item 5: 2 Flatwasher ø35 (ø1-3/8")
Item 6: 1 Pin ø35 (ø1-3/8"
Item 7: 2 Spring Pin ø8x50 (5/16"x2") DIN 1481
Item 10: 1 Bolt M16x40 (5/8"x1-9/16") DIN 933 8.8
Item 12: 1 Grease Nipple M6
Assembly Section 3-20
Advertisement
Table of Contents
