Marking Track Numbers - Sony MXD-D400 Operating Instructions (primary manual) Operating Instructions Manual

3
Press REC MODE repeatedly to select
the recording mode.
Select the desired recording time.
To record in Select
Stereo Blank (No
indicator)
LP2 Stereo LP2
LP4 Stereo LP4
Monaural MONO
*Maximum recording time using a 60-minute
MD.
4
Press z.
The MD deck stands by for recording.
5
Start playing the desired source to
record.
6
Press T.REC at the desired point to
start recording.
To stop Time Machine Recording
Press x.
Note
The MD deck starts storing audio data when the deck
stands by for recording in step 4 and you start playing
the source. If less than 6 seconds have passed when you
press T.REC (or AMS), Time Machine Recording
starts with less than 6 seconds of audio data.
Tip
For details about LP2/LP4 recording, see "Recording
for long times" on page 29.
Recording time*
After recording
60 minutes
Use the Divide Function (page 40).
120 minutes
240 minutes
At any point during recording
120 minutes
— Track Mark
You can mark track numbers during manual
recording of any source.
Press z during manual recording at the
point you want to add a track mark.
Presetting to automatically
mark track numbers before
recording
— Level-Synchro Recording
The Level Synchro Recording Function is
factory set to on, so the track numbers are
automatically marked. Track numbers are
automatically marked when the input signal is
continuously below a certain level for more than
two seconds and then exceeds that level. If
"L
turn on the Level Synchro Recording as follows.

Marking track numbers

.
SYNC" does not appear during recording,
1
2,5
3,4
3,4
continued
GB
23