Adjusting The Speaker Volume - Sony MHC-M500AV Operating Instructions (primary manual) Operating Instructions Manual

Step 2: Setting up the speakers
(continued)

Adjusting the speaker volume

To enjoy Dolby Pro Logic Surround sound, turn
the Dolby Pro Logic mode on, then adjust the
volume of each speaker using the test tone that the
system provides.
1
2,4
PRO LOGIC
ON/OFF
1
Press PRO LOGIC (or PRO LOGIC
ON/OFF on the remote).
"PRO LOGIC ON" appears.
8
H
h H
h H
3
2
Press T.TONE ON/OFF on the remote.
The test tone is heard from the speakers in
the following order. Adjust the volume of the
test tone.
Front (left) t Center t Front (right)
R
Rear T
3
From your listening position, press
CENTER LEVEL (+/–) and REAR
LEVEL (+/–) on the remote to adjust
the volume.
The volume levels from each speaker must
become the same.
4
Press T.TONE ON/OFF when you are
done adjusting.
The test tone turns off.
Tip
If you turn VOLUME (or press VOLUME +/– on the
remote), all the speaker volumes change.
Note
The test tone feature works only for Dolby Pro Logic
Surround sound.