Table of Contents
Advertisement
5. Now the frequency has to be adjusted by repeating step 4 with different values. The
frequency will be lower with a higher value of the capacitance array.
6. When the desired accuracy of the 32 MHz clock is obtained, store the corresponding
trim value to the parameter Osc_Trim of the BD-data. This can be done by clicking
the button "Write BD-Data" in HCI Lite tool. In the pop-up window, only change the
parameter OSC_Trim to the calibrated value and give the module an individual
BD_ADDR. (See in
7. Issue a HW reset of the device.
Application Note
Design Guide
Figure
27)
63
PAN1322
Revision 1.2, 2013-12-18
Advertisement
Table of Contents
