Mechanical Design - Siemens SENTRON PAC5200 Device Manual

3 Device Design

3.1 Mechanical Design

3.1 Mechanical Design
The electrical modules are installed in a plastic case with the dimensions 96 mm x 96 mm x 100 mm
(W x H x D).
In panel flush mounting devices, the display side accommodates the display, 4 softkeys located below and 4
LEDs of which the H1, H2, and ERROR LEDs can be parameterized. The ERROR LED can only be
parameterized for error messages.
The device top side holds the RJ45 Ethernet plug connector with 2 LEDs. 4 additional LEDs are identical to the
LEDs on the display side. At the cover of the battery compartment there is a labeling strip for the configurable
LEDs H1/H2 and a battery symbol that indicates the polarity. The label is also located on the top side and
provides among other information the most important rated data of the device. A lithium battery is located under
the removable cover of the battery compartment.
On the terminal side are available: terminals for all inputs and outputs, terminals for power supply and
protective grounding.
Cover of battery
compartment
LED RUN
LED H1
Softkeys
F1 to F4
Figure 3-1
NOTE
DIN rail devices have a DIN rail support instead of the display. Therefore, this device side is referred to as the
DIN rail side.
22
Display side
Default IP address
Default subnet mask
Display
LED H2
Layout of the Panel Flush Mounting Version of SENTRON PAC5x00 with Display
RJ45 with
2 LEDs
Terminal block for
binary outputs
LED ERROR
Terminal blocks for
measurements (voltage, current)
SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
Terminal side
4 LEDs
Terminal block for
power supply
E50417-H1040-C568-A1, Edition 03.2015