Installing The Manual Crank For Hi/Lo Function - Invacare IVC Series Owner's Operator And Maintenance Manual

Installing
1. Slide the cables into the appropriate cable lock slots.
2. Depress the cable lock clips.
3. Push the cable lock clips into the locking slots on the junction box, until they click in place.
Removing
1. Compress the cable lock clips firmly.
2. Carefully pull the cable lock away from the junction box.
3. Slide the cable lock off of the cables.

Installing the Manual Crank for Hi/Lo Function

NOTE: For this procedure, refer to FIGURE 4.13 on page 31.
1. Pinch the ears on the input drive shaft
cover to open the cover.
2. Flip the input drive shaft cover up and
push until it attaches to the gear box.
The cross pins will now be accessible.
3. Connect the manual crank to the cross
pins until the spring engages the cross
pins.
4. Unfold the handle on the hand crank.
Part No 1114836
SECTION 4—PACKAGING, HANDLING, AND SET-UP
Junction Box
Cables
Locking Slot
FIGURE 4.12 Installing/Removing Cable Lock
Locking Slot
Cable
Lock Clip
Cable Lock
Slots
Gear Box
Cross
Pins
Spring
FIGURE 4.13 Assembling the Drive Shaft
31
Cable
Lock
Cable
Lock Clip
Ears
Input Drive
Shaft
Cover
Crank
Handle
™
IVC Bed Series