Optional Components; Hooking Up Optional Components; Listening To Audio From A Connected Component; Recording On A Connected Component - Sony CMT-CP101 Primary Operating Instructions Manual

Optional Components

Hooking up optional components

To enhance your system, you can connect optional components. Refer to the operating instructions
provided with each component.
A AUDIO IN (MD/VIDEO) jacks
Use audio cords (not supplied) to connect an
MD deck or VCR to these jacks. You can then
listen to analog audio from the MD deck or
VCR through this system.
B OPTICAL DIGITAL OUT (CD) jack
Use a digital optical cable (square, not
supplied) to connect an MD deck to this jack.
You can then output the digital audio to the
MD deck from this system. If the jack is
covered with a cap, remove it before use.
GB
18
MD deck / VCR
From the audio output
jacks of an MD deck /
VCR
Listening to audio from a
connected component
1
Connect the audio cords.
2
Press FUNCTION repeatedly until "MD"
or "VIDEO" appears.
Start playing the connected component.
Tip
If you cannot select "VIDEO" by pressing
FUNCTION repeatedly, turn off the system and then
press CD x and FUNCTION at the same time. The
function will change from "MD" to "VIDEO", and
"VIDEO" will appear in the display. To change back
to "MD", repeat this procedure.
Recording on a connected
component
1
Connect the digital optical cable.
2
Start recording.
Refer to the operating instructions provided
with connected component.
MD deck
To the digital input jack of
an MD deck