Display Screen - Sullair ShopTek User Interface Manual

CONTROLLER USER INTERFACE MANUAL
S T
™
HOP EK
4.4

DISPLAY SCREEN

Information relevant to the compressor operation is
presented in three views on the controller display
screen: Normal View, Main Status Views, Customer
Set Views.
In addition to the standard views, two information
screens are displayed when power is first supplied to
the compressor. Refer to Figure 4-1.
screen shows "SULLAIR" along with the serial
number of the compressor. Refer to Figure 4-2. The
second screen shows the total operation time of the
compressor along with the controller software
revision level and date of manufacture.
these screens will display for 3 seconds before the
Normal View is displayed.
SULLAIR
XXXXXXXXX
Figure 4-1: Information Screen 1
RUN: XXXXXXH
REV: X.X
Figure 4-2: Information Screen 2
NORMAL VIEW
The Normal View is the default view for the display
screen. When in Normal View, information regarding
the compressor current operating conditions appears
on the display screen. See Figure 4-3.
The top line of the display screen in Normal View
shows the current compressor operating mode and
state. The lower line of the Display Screen displays
the discharge pressure and the internal temperature
of the compressor package.
24
The first
Each of
2007/01
02250180-094 R00
AUTO
174°F
Figure 4-3: Display Screen Normal View Example
The Display Screen will also display fault conditions
when they occur.
MAIN STATUS VIEW
The Main Status View shows real-time machine
measurement information.
This information is quickly accessed using the Down
navigational arrow. The top line of the display screen
will indicate the measurement . See Figure 4-4. The
second line will show the current value of the
measurement being viewed.
TOTAL RUN TIME:
337H
Figure 4-4: Display Screen Main Status View
Example
Listed below are compressor attributes that may be
viewed in the Main Status View.
TOTAL RUN TIME – Displays the total time the
compressor has been running loaded or unloaded.
LOADED TIME – Displays the total time the
compressor has been running loaded.
MAIN (A) - Feature not available.
THIS RUN TIME – Displays the total time the
compressor has been running loaded or unloaded
since the most recent startup.
THIS LOADING – Displays the total time the
compressor has been running loaded since the most
recent startup.
OIL FILTER – Displays the total time on the oil filter
since the last service.
A-O SEPARATOR - Displays the total time on the
separator element since the last service.
AIR FILTER – Displays the total time on the air filter
SECTION 4
LOAD
62PSI
20M